ATR Discussion Forums Homepage
Forum Home Forum Home > ATR Discussion Forums > FAQ (Frequently Asked Questions)
  New Posts New Posts RSS Feed - Load the ATR over FS default start flight
  FAQ FAQ  Forum Search   Register Register  Login Login

Load the ATR over FS default start flight

 Post Reply Post Reply
Author
Message
dreamfleet1 View Drop Down
Senior Member
Senior Member


Joined: October-30-2004
Location: United States
Points: 242
Post Options Post Options   Thanks (0) Thanks(0)   Quote dreamfleet1 Quote  Post ReplyReply Direct Link To This Post Topic: Load the ATR over FS default start flight
    Posted: October-30-2004 at 7:12pm

It is essential that you don't load the ATR after any third party aircraft. You can start FS with the ATR selected in your default flight and you also may load it after any default aircraft (preferrably the Cessna 172). Location, weather, time and season don't make a difference.

Loading the ATR in place of another 3rd party aircraft, especially a complex one, will almost certainly cause problems with the operation of the ATR.

This advice also applies to almost any 3rd party aircraft you may wish to load into FS for the first time.

Finally:

Always save your flight with the ATR from the 2D cockpit view, and no other view. Doing this will allow the gauges and systems to initialize properly upon re-loading. This advice also applies to most other complex 3rd party aircraft.

For complete information on this topic, please see section 1 or section 18 of the manual, where there is a full page notice with instructions concerning this.

Regards,

Flight One 737-200 Developer
Flight One ATR Developer
Flight One 152 Developer
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.109 seconds.